Timber Door with Metal Frame Installation Instructions

STEPS 1

a) Preparation of Masonry / Structural openings to receive steel door frames

• Check the structural openings before installation of frames.

•Check the frame size.

•Ensure that there is a given allowance of approximately 10-20mm gap between the

intended frame and the structural opening

b) Alignment and leveling

• Check for Finishing Floor Level (FFL) reference line.

• Check if there are other finishes to the structural wall and door frame.

• Left: Use of laser leveling device mounted on tripod.

• Right: Checking of door’s 1m reference line.

STEPS 2

c) Installation of steel frames

•Install the frame together.

• Position the frame in the opening with timber shims (temporary support) if necessary.

• Ensure that frame is straight. Use plumb bobs, attached to the site and front of the frame

to confirm frame’s verticality.

• Once the frame is aligned properly, frame is secured to the structural wall provision.

• Frame with metal strap, secure the metal strap using plastic anchors or impact

anchors for RC walls.

•Left: Positing of frame in the opening.

•Right: Checking of frameDepending on design, the frames are

•Secured using metal straps.’s verticality using plumb bob and plumb lines.

STEPS 3

d) Filling of Voids using Cement

•Allow 24hrs for the cement to set.

Grouting of voids between door frame and wall. Usage of timber strips to ensure that

cement is compacted properly.

STEPS 4

e) Handling of Doors Panel

• Door panel shall be installed once the cement for the frame had set.

• Secure hinges to the panel before installation.

• Left: Align door panels to frame. Secure the hinges to frame using 1-2 screws per hinges.

• Right: Door panels shall be adjusted to ensure that panel are installed properly. Secure all

screws once alignment is achieved.

f) Lock set

The lock set shall be installed after the installation of the door panel. Operate the

lock a few times with lever handle or key to ensure that the latch and the deadbolt

are functioning smoothly. Ensure that the level handle returns to its original position

smoothly.

g) Door Closer

Adjust the speed of the closing and back check of the door closure after installation. Ensure that the door close at an appropriate speed and this action is able to engage the latch upon closing.

Any further assistant can contact [email protected] 008615618225603 for help.